Astro Van 2WD V6-4.3L VIN X (2002)
1. Install EBCM (2) on to the BPMV (5).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the 4 new T-25 Torx screws (1) in the EBCM (2).
^
Tighten the 4 T-25 Torx screws to 5 Nm (39 inch lbs.) in an X-pattern.
3. Connect the electrical connectors to the EBCM.
4. Secure the module (1) to the frame bracket (3) and fuel pipe shield (2) with the two nuts (4).
5. Revise the tire calibration using the Scan Tool Tire Size Calibration function.
6. Return to Diagnostic System Check - ABS on. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check
