Astro Van 2WD V6-4.3L VIN X (2002)
3. Install the 1-2 and 2-3 shift solenoids.
4. Install the 1-2 and 2-3 shift solenoid retainers.
5. Install the pressure control solenoid. Ensure that the electrical tabs are facing outboard.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the pressure control solenoid retainer and retaining bolt.
Tighten the pressure control solenoid retaining bolt to 11 Nm (97 inch lbs.).
7. Connect the internal wiring harness electrical connectors to the following components:
^
Transmission fluid pressure switch (1)
^
1-2 shift control solenoid (2)
^
2-3 shift control solenoid (3)
^
Pressure control solenoid (4)
^
TCC PWM solenoid (5)
^
3-2 control solenoid (6)
8. Install the 1-2 accumulator.
