Astro Van AWD V6-4.3L VIN X (2003)
Hood Hinge: Service and Repair
Hood Hinge Replacement
Removal Procedure
1. Remove the air inlet panel grille. Refer to Air Inlet Grille Panel Replacement (See: Cowl/Cowl Moulding / Trim/Service and Repair) .
Caution: Refer to Hood Hold-Open Device Caution in Cautions and Notices.
2. Raise and support the hood.
3. Remove the hinge to fender nut.
4. Remove the hinge to fender bolt.
5. Using a grease pencil, mark the position of the hinge to hood.
6. Remove the hinge to hood bolts.
7. Remove the hinge from the hood.
Installation Procedure
1. Install the hinge to the hood with the aid of an assistant.
2. Align the new hinge according to the marks made before the old hinge was removed.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the hood to hinge bolts.
