Astro Van AWD V6-4.3L VIN X (2003)
Installation Procedure
1. Install the control rod and the retainer to the latch.
2. Install the retainer as shown in order to prevent squeaks and rattles.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the following components to the door. Ensure that the arrow on the retainer points toward the front of the vehicle:
*
The latch
*
The retainer
*
The bolts
Tighten the bolts to the door to 8 N.m (71 lb in).
Important: Install new nylon retainers whenever you remove the control rods.
4. Install the control rod to the lock assembly.
5. Install the water deflector. Refer to Water Deflector Replacement See: Doors/Rear Door/Rear Door Panel/Service and Repair
6. Install the trim panel. Refer to Trim Panel Replacement - Rear Door (Cargo Doors) (See: Interior Moulding / Trim/Console/Service and
Repair/Trim Panel Replacement - Rear Door (Cargo Doors))Trim Panel Replacement - Rear Door (E54) (See: Interior Moulding /
Trim/Console/Service and Repair/Trim Panel Replacement - Rear Door (E54)) .
