Astro Van AWD V6-4.3L VIN X (2003)
Installation Procedure
1. Install the anti-rattle clips to the brake caliper bracket.
2. Install the brake pads to the brake caliper bracket.
3. Install the brake caliper to the mounting bracket.
4. Install the tire and wheel assembly.
5. Lower the vehicle.
6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
7. Slowly release the brake pedal.
8. Wait 15 seconds, then repeat steps 6-7 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
9. Fill the master cylinder reservoir to the proper level with clean brake fluid.
10. Burnish the brakes pads and rotors as necessary.
