Astro Van AWD V6-4.3L VIN X (2003)
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
1. Install EBCM (2) onto BPMV (5).
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
Important: Do not reuse the old mounting bolts. Always install new bolts with the new BPMV.
2. Install the 4 EBCM bolts (1).
Tighten the 4 bolts to 5 Nm (39 inch lbs.) in an X-pattern.
3. Connect the 2-way ABS pump motor connector to the EBCM.
4. Install the BPMV (5) to the BPMV mounting bracket (3) with the 2 bolts (4).
5. Slide the EHCU (1) back onto the frame bracket (2).
Important: The brake pipes are held in the proper place by a frame mounted plastic bracket. Make sure that the brake pipes stay in the correct place
for proper reassembly.
6. Install the 5 brake pipes to the EHCU (1).
Tighten the brake pipe fittings to 30 Nm (22 ft. lbs.).
7. Connect the 2 electrical harness connectors to the EBCM (1).
8. Secure the module (1) to the frame bracket (3) and fuel pipe shield (2) with the 2 nuts (4).
9. Bleed the brake system.
10. Return to Diagnostic System Check-ABS.
