Astro Van AWD V6-4.3L VIN X (2003)
Parking Brake Backing Plate: Service and Repair
Park Brake Cable Mounting Bracket Replacement
Removal Procedure
1. Release the parking brake.
2. Raise and support the vehicle.
3. Disconnect the rear cables from the equalizer.
4. Remove the rear cables from the mounting bracket by depressing the retaining tabs and pulling rearward.
5. Remove the cable support bracket bolts.
6. Remove the cable support bracket.
Installation Procedure
1. Install the cable support bracket.
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
2. Install the cable support bracket bolts.
Tighten the bolts to 24 Nm (18 ft. lbs.).
3. Install the rear cables to the mounting bracket by inserting the cable until all the retaining tabs snap into place.
4. Connect the rear cables to the equalizer.
5. Remove the safety stands and lower the vehicle.
