Astro Van AWD V6-4.3L VIN X (2003)
9. When the coil is fully seated on the front head, mark the front head at 3 places 120 degrees apart.
10. Use a 1/8 inch diameter drift punch (2) in order to stake the front head at 3 places 120 degrees apart (3), in order to ensure that the clutch coil (1)
remains in position.
IMPORTANT: Ensure that the stake size is only one-half the area of the punch tip. Ensure that the stake is only approximately 0.28-0.35 mm
(0.010-0.015 in) deep.
11. With the compressor mounted to the J 34992, position the pulley rotor (1) and bearing assembly on the front head.
12. Position the J 33017 and the J 33023-A directly over the inner race of the bearing.
13. Position the J 8433-1 on the J 33023-A.
14. Assemble the two bolts and washers through the puller bar slots.
15. Thread the bolts into the J 34992. Ensure that the thread of the through bolts engages the full thickness of the J 34992.
16. Tighten the center screw in the J 8433-1 in order to force the pulley rotor and bearing assembly onto the compressor front head.
17. If the J 33017 slips off direct in-line contact with the inner race and bearing, perform the following steps:
17.1. Loosen the J 8433-3.
17.2. Realign the installer and the pilot in order to ensure that the J 33017 properly clears the front head.
