Astro Van AWD V6-4.3L VIN X (2003)
8. Remove the evaporator tube (2) from the condenser (4).
9. Remove the O-ring seal.
INSTALLATION PROCEDURE
1. Install the new O-ring seal.
2. Install the evaporator tube (2) to the condenser (4).
3. Tighten the evaporator tube nut (3) to the condenser (4).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nut to 28 N.m (20 lb ft).
4. Install the grille.
5. Install the new O-ring seal.
6. Install the evaporator tube to the evaporator.
7. Tighten the evaporator tube nut at the evaporator.
Tighten
Tighten the nut to 28 N.m (20 lb ft).
8. Evacuate and recharge the system.
9. Leak test the fittings of the component using the J 39400-A.
10. Install the air cleaner.
Evaporator Tube Replacement (With RPO Code C69)
EVAPORATOR TUBE REPLACEMENT ((WITH RPO CODE C69)
TOOLS REQUIRED
-
J 38778 Door Trim Pad and Garnish Clip Remover
-
J 39400-A Halogen Leak Detector
REMOVAL PROCEDURE
1. Remove the air cleaner.
2. Remove the accumulator.
3. Remove the grille.
