Astro Van AWD V6-4.3L VIN X (2003)
Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
^
Tools Required
-
J 41712 Oil Pressure Switch Socket
Removal Procedure
1. Remove the engine cover.
2. Disconnect the engine oil pressure sensor gage electrical connector.
3. Hold the engine oil pressure gage sensor fitting with a wrench.
4. Remove the engine oil pressure gage sensor using J 41712.
Important: Note the alignment of the engine oil pressure gage sensor fitting prior to removal.
5. Remove the engine oil pressure gage sensor fitting, if necessary.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.