Astro Van AWD V6-4.3L VIN X (2003)
8. Pull straight up on the fuel pipes in order to remove the fuel pipes from the fuel meter body.
9. Remove the O-ring seals from both ends of the fuel feed and return pipes.
10. Discard the O-ring seals.
INSTALLATION PROCEDURE
1. Assemble the new O-rings into the inlet and outlet of the fuel meter body.
2. Apply a few drops of clean engine oil to the male tube ends.
CAUTION: Refer to Fuel Pipe Fitting Caution in Service Precautions.
3. Install the fuel feed and return pipes to the fuel meter body.
4. Install the fuel pipe retainer and the attaching nuts.
Once installed, pull on both ends of each connection in order to make sure they are secure.
5. Install the rear fuel pipe bracket retaining bolt.
NOTE: Refer to Fastener Notice in Service Precautions.