Astro Van AWD V6-4.3L VIN X (2003)
5.1.
Remove and discard the improperly installed rivet.
5.2.
Reattach the sensor with a new rivet.
6. Perform the following steps, if needed, in order to complete a second fastener repair:
6.1.
Remove the improperly installed rivet.
6.2.
Enlarge the mounting holes in the lower radiator support to 9.0 mm (0.35 in).
6.3.
Insert and properly seat the rivnut.
6.4.
Install the screw to the sensor.
Tighten
Tighten fasteners to 6.5 N.m (58 lb in).
7. Connect the inflatable restraint front end discriminating sensor harness connector to the sensor.
8. Lower the vehicle. Refer to Vehicle Lifting.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1.
