Astro Van M V6-262 4.3L VIN W CPI (1992)
Hinge Components
Remove or Disconnect
Tool Required: J 09886-01 Door Handle Clip Remover and J 38778 Trim Pad and Garnish Clip Remover.
1. Two screws and armrest cover.
^
Slide the armrest cover toward the rear of the door.
2. Window handle using J 09886-01 (if equipped).
3. Assist handle cover using J 38778.
A. Pry the cover from the door near the clips.
B. Switch connectors (if equipped).
4. Screw from behind the armrest pad.
5. Trim panel retainers from the door using J 38778.
6. Trim panel from the door.
Install or Connect
NOTICE: For steps 3 and 6. When fasteners are removed, always reinstall them at the same location from which they were removed. If a fastener needs
to be replaced, use the correct part number fastener for that application. If the correct part number fastener is not available, a fastener of equal size and
strength (or stronger) may be used. Fasteners that are not reused, and those requiring thread locking compound will be called out. The correct torque
value must be used when installing fasteners that require it. If the above conditions are not followed, parts or system damage could result.
1. Trim panel retainers to the trim panel.
2. Trim panel to the door.
^
Place the window seal portion of the panel over the door frame.
3. Screw behind the armrest pad.
Tighten: Trim panel screw to 1.9 Nm (17 lbs. in.).
4. Assist handle cover to the door.
^
Electrical connectors (if equipped).
5. Window handle (if equipped).
6. Armrest with screws.
^
Insert the tabs into the slots and push the armrest toward the front of the door.
Tighten: Armrest screws to 1.9 Nm (17 lbs. in.).
