Astro Van M V6-262 4.3L VIN Z (1994)
2.
Remove the relay from the multi-use bracket. See Figure 1, View A.
3.
Unwrap tape from the harness from relay back to major conduit.
4.
Cut harness wires at base of original connector. This will provide maximum wire length for splices.
5.
Using crimp connectors included in service kit (P/N 12166225 Blower Relay Service Kit), splice leads from numbered cavities on new connector
to color coded leads from original harness as follows:
6.
Splice lead from cavity 30 to purple lead.