Avalanche 1500 2WD V8-5.3L (2008)
8. Remove the knuckle from the vehicle.
Installation Procedure
1. Install the knuckle on the lower ball joint. Refer to Lower Control Arm Replacement (1500) (See: Control Arm/Service and Repair/Front
Suspension/Lower Control Arm Replacement (1500))Lower Control Arm Replacement (2500) (See: Control Arm/Service and Repair/Front
Suspension/Lower Control Arm Replacement (2500)) .
2. Install the upper ball joint in the knuckle. Refer to Upper Control Arm Replacement (2500) (See: Control Arm/Service and Repair/Front
Suspension/Upper Control Arm Replacement (2500))Upper Control Arm Replacement (1500) (See: Control Arm/Service and Repair/Front
Suspension/Upper Control Arm Replacement (1500)) .
3. Install the outer tie rod end. Refer to Steering Linkage Outer Tie Rod Replacement (See: Steering/Tie Rod/Service and Repair/Steering Linkage
Outer Tie Rod Replacement) .
4. Install the wheel bearing and hub assembly. Refer to Front Wheel Hub, Bearing, and Seal Replacement (1500) (See: Wheel Hub/Service and
Repair/Front Wheel Hub, Bearing, and Seal Replacement (1500))Front Wheel Hub, Bearing, and Seal Replacement (2500) (See: Wheel
Hub/Service and Repair/Front Wheel Hub, Bearing, and Seal Replacement (2500)) .
5. Install the wheel drive shaft, if equipped. Refer to Wheel Drive Shaft Replacement (2500) (See: Transmission and Drivetrain/Drive Axles,
Bearings and Joints/Axle Shaft Assembly/Service and Repair/Wheel Drive Shaft Replacement - 2500 Series)Wheel Drive Shaft Replacement
(1500) (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Wheel Drive Shaft
Replacement - 1500 Series) .