Avalanche 1500 2WD V8-5.3L VIN T (2002)
Rear Door Exterior Handle: Service and Repair
Door Handle Replacement
LOCK ROD AND OUTSIDE HANDLE REPLACE - REAR DOOR
REMOVAL PROCEDURE
1. Remove the trim panel, as necessary.
2. Pull back the water deflector, as necessary.
3. Disconnect the lock cylinder rod from the rod clip.
4. Remove the outside handle nuts.
5. Remove the outside handle.
6. Disconnect electrical connector if required.
7. Remove actuator cable.
8. Remove the door lock cylinder.
9. Complete the necessary procedures:
^
For repair of a binding lock cylinder, refer to Binding Lock Cylinders.
^
For coding a new lock cylinder, refer to Key and Lock Cylinder Coding.
INSTALLATION PROCEDURE
IMPORTANT: When installing a new lock cylinder, apply GM P/N 12345120, or Canadian P/N 726548, lubricant or a similar lubricant to the
inside of the lock case and the cylinder keyway.
1. Install the door lock cylinder.
2. Install the actuator cable.
