Avalanche 1500 2WD V8-5.3L VIN T (2002)
Parking Brake Warning Switch: Service and Repair
Park Brake Warning Lamp Switch Replacement
Removal Procedure
1. Remove the body wiring harness junction block but do not disconnect the harness.
2. Remove the park brake warning lamp switch mounting bolt.
3. Remove the park brake warning lamp switch.
Installation Procedure
1. Install the park brake warning lamp switch.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the park brake lamp switch mounting bolt.
Tighten the bolt to 3 Nm (25 inch lbs.).
3. Install the body wiring harness junction block.
