Avalanche 1500 2WD V8-5.3L VIN Z Flex Fuel (2005)
Ride Height Sensor: Service and Repair
Front Position Sensor Replacement - Electronic Suspension (15 Series)
Front Position Sensor Replacement - Electronic Suspension (15 series)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the sensor harness connector from the vehicle harness connector.
3. Remove the wheel speed sensor wire from the Electronic Suspension Control (ESC) sensor bracket.
4. Remove the wheel speed sensor wire from the ESC sensor bracket.
5. Remove the ESC sensor link bracket bolt from the upper control arm.
6. Remove the bolt from the frame.
7. Remove the position sensor from the vehicle.
Installation Procedure
1. Install the position sensor on the vehicle.
2. Install the bolt to the frame.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
