Avalanche 1500 2WD V8-5.3L VIN Z Flex Fuel (2005)
Ride Height Sensor: Service and Repair
Rear Position Sensor Replacement - Electronic Suspension - Right
Rear Position Sensor Replacement - Electronic Suspension - Right
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel from the vehicle.
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Disconnect the sensor link from the ball stud.
5. Remove the bolts.
6. Remove the position sensor from the vehicle.
Installation Procedure
1. Install the position sensor on the vehicle.
2. Install the bolts.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Connect the sensor link to the ball stud.
