Avalanche 1500 4WD V8-5.3L (2007)
8. Install the following parts onto the steering column shaft assembly:
^
Lubricate the inner race (1) with GM P/N 12345718 (Canadian P/N 10953516).
^
The inner race (1)
^
The upper bearing inner race seat (2)
^
The upper bearing spring (3)
^
Lubricate the turn signal cancel cam assembly (4) with GM P/N 12377900 (Canadian P/N 10953529).
^
The turn signal cancel cam assembly (4) onto the steering assembly
^
The cam orientation plate (5)
9. Install the new bearing retainer onto the steering shaft assembly.
10. Compress the cam orientation plate using J 23653-SIR and J 42137.
11. Firmly seat the bearing retainer into the groove on the steering shaft assembly.
12. Remove the J 23653-SIR.
13. Install the linear shift and the automatic transmission shift lock control only.
14. Install the tilt spring only.
15. Install the turn signal multifunction switch.
16. Install the ignition lock cylinder case.
17. Install the SIR coil.
18. Install the steering column into the vehicle.
19. Enable the SIR system. Refer to SIR Disabling and Enabling.
