Avalanche 1500 4WD V8-5.3L VIN Z Flex Fuel (2005)
1. Remove expanding plastic fasteners at window latch close-out.
2. Using the J 38778 , release the retainers from the retainer seats.
3. Remove the trim panel from the liftgate.
INSTALLATION PROCEDURE
1. Align the retainers with the holes in the liftgate.
2. Apply pressure to the seat retainers.
3. Install the expanding plastic retainers at the window latch close-out.
Garnish Molding Replacement - Rear Upper
GARNISH MOLDING REPLACEMENT - REAR UPPER
REMOVAL PROCEDURE
1. Remove the rear window from the vehicle.
2. Remove the third pillar trim panels.
3. Remove the plastic push pins (1) from the upper garnish molding.
4. Pull down the upper garnish molding in order to disengage the retaining clips.
5. Disconnect the electrical connector, if equipped.
INSTALLATION PROCEDURE
1. Connect the electrical connector, if equipped
2. Install the upper garnish molding until it snaps into place.
3. Install the plastic push pins (1) to the upper garnish molding.
