Avalanche 2500 2WD V8-8.1L VIN G (2002)
8. Pull the rest of the cover down using a side-to-side motion.
9. Install the armrests, if equipped.
10. Install the head restraint retainers.
11. Fit the seat cover around the air bag cover.
12. Pull the seat belt down through the seat cushion and install the outboard seat belt anchor nut.
Tighten
Tighten the nut to 53 N.m (39 lb ft).
13. Install the seat trim panel.
14. Install the head restraints.
15. Push on the seat cover. Ensure that the cover is retained by the velcro in the seat cushion.
16. Connect the J-strip at the bottom of the seat.
17. If equipped with side air bags, enable the air bag module. Refer to Enabling the SIR System in Restraint Systems.
