Avalanche 2500 2WD V8-8.1L VIN G (2002)
2. Install the caliper pin boots (4) to the disc brake caliper mounting bracket (3).
3. Install the disc brake pad retainers to the disc brake caliper mounting bracket.
4. Install the disc brake pads to the disc brake caliper mounting bracket.
5. Install the disc brake caliper to the caliper mounting bracket.
6. With the engine OFF, gradually apply the brake pedal approximately 2/3 of its travel distance.
7. Slowly release the brake pedal.
8. Wait 15 seconds, then repeat steps 7-8 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
Rear
Disc Brake Replacement - Rear
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.