Avalanche 2500 2WD V8-8.1L VIN G (2002)
Intake Air Temperature Sensor: Service and Repair
MASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR REPLACEMENT
REMOVAL PROCEDURE
IMPORTANT: Take care when handling the mass air flow/intake air temperature (MAF/IAT) sensor. Do not dent, puncture, or otherwise damage
the honeycell located at the air inlet end of the MAF/IAT. Do not touch the sensing elements or allow anything including cleaning solvents and
lubricants to come in contact with them. Use a small amount of a non-silicone based lubricant, on the air duct only, to aid in installation. Do not drop
or roughly handle the MAF/IAT sensor.
1. Remove Air Intake Resonator.
2. Disconnect the MAF/IAT sensor electrical connector.
3. Loosen the clamp securing the MAF/IAT (4) sensor to the air cleaner housing (5).
4. Remove the MAF/IAT (4) sensor from the air cleaner assembly (5).
INSTALLATION PROCEDURE
IMPORTANT: The embossed arrow on the MAF/IAT sensor indicates the proper air flow direction.The arrow must point toward the engine.
1. Locate the air flow direction arrow (2) on the MAF/IAT sensor.
