Avalanche 2500 2WD V8-8.1L VIN G (2002)
Ride Height Sensor: Service and Repair
Front Position Sensor Link Assembly Replacement - Electronic Suspension
Front Position Sensor Link Assembly Replacement - Electronic Suspension
Tools Required
^
J38185 Spring Hose Clamp Pliers
Removal Procedure
Important: Do not attempt to pry the link rod from the Real Time Damping (RTD) ball stud. If the link rod needs to be replaced or disconnected you
must use the following procedure.
1. Remove the RTD sensor from the vehicle.
2. While supporting the sensor lever by hand, twist the link rod to remove it from the ball stud.
3. Remove the link rod from the mounting bracket ball stud.
Installation Procedure
1. Using the J38185 install to link rod to the ball stud on the sensor lever and the mounting bracket.
2. Install the RTD sensor to the vehicle.
