Avalanche 2500 4WD V8-8.1L VIN G (2003)
4. From the inside of the housing push in the tabs and remove.
5. Remove the bezel by pushing it through the fascia.
INSTALLATION PROCEDURE
1. Paint the new rear object sensor. Refer to Basecoat/Clearcoat Paint Systems in Paint/Coatings.
IMPORTANT: Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative.
2. Check to make sure the paint does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals. Refer to Paint Gages in
Paint/Coatings.
3. Paint the sensor bezel to match the color of the bumper fascia.
