Avalanche 2500 4WD V8-8.1L VIN G (2003)
Speaker: Service and Repair
Speaker Replacement - Front Floor Console (Subwoofer Speaker)
REMOVAL PROCEDURE
1. Remove the 2 front seats.
2. Move the center console rearward slightly in order to disconnect the wire connector.
3. Move the console rearward to gain access to the subwoofer speaker.
4. Remove the 4 retaining bolts from the speaker.
5. Disconnect the wire connector.
6. Remove the speaker from the subwoofer assembly.
INSTALLATION PROCEDURE
1. Install the speaker into the subwoofer assembly.
2. Connect the wire connector.
3. Install the 4 retaining screws.
Ensure the screw follows the same thread in the screw boss so that a new thread is not formed.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 6 N.m (53 lb in).
4. Move the console forward in order to connect the wire connector.
5. Install the console to the I/P.
6. Install the 2 front seats.
