Avalanche 2500 4WD V8-8.1L VIN G (2003)
Trunk / Liftgate Hinge: Service and Repair
Hinge Replacement - Removable Rear Panel - Mid Gate
HINGE REPLACEMENT - REMOVABLE REAR PANEL - MID GATE
REMOVAL PROCEDURE
1. Fold the rear seat back down.
2. Ensure the rear mid gate is in the upright position, latched.
3. Remove the hinge trim cover (1) from the mid-gate.
4. Remove the retaining nuts from the hinge.
5. Remove the hinge from the vehicle.
INSTALLATION PROCEDURE
1. Install the hinge to the vehicle.
2. Install the four retaining nuts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nuts to 25 N.m (18 lb ft).
3. Install the hinge trim cover (1) by pressing into place.
4. Fold the rear seat back up.
