Avalanche 2500 4WD V8-8.1L VIN G (2003)
12. Install the front nuts (2) onto the studs on the underside of the cushion.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nuts to 21 N.m (15 lb ft).
13. Install the front seat trim panel.
14. Re-zero the Inflatable Restraint Passenger Presence System.
Seat Back Cover and Pad Replacement - Front
SEAT BACK COVER AND PAD REPLACEMENT - FRONT
REMOVAL PROCEDURE
1. If equipped with side air bags, disable the air bag module.
CAUTION: Refer to SIR Caution in Service Precautions.
2. Remove the head restraint.
3. Remove the seat trim panel.
4. Remove the nut from the lower seat belt anchor.
5. Disengage the J-strip retainer on the bottom of the seat back cover.
6. Disconnect the heater seat element connector, if equipped.
