Avalanche 2500 4WD V8-8.1L VIN G (2003)
Tailgate Release Handle: Service and Repair
Endgate Handle Replacement
Endgate Handle Replacement
Removal Procedure
1. Remove the endgate handle bezel.
2. Release the endgate handle linkage rod retainers.
3. Remove the 3 bolts (1) that retain the handle to the endgate.
4. Remove the endgate spoiler.
5. Remove the handle.
Installation Procedure
1. Set the handle in position in the endgate.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants,
or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may
damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
2. Install the 3 bolts (1) that retain the handle to the endgate. Tighten the bolts to 25 Nm (18 lb ft).
3. Install the endgate spoiler.
4. Reattach the handle linkage rods and adjust the endgate latch.
5. Reattach the endgate handle bezel.
