Avalanche 2500 4WD V8-8.1L VIN G (2003)
pipe fitting end.
5. Remove the brake hose retaining clip (3) from the brake hose mounting bracket.
6. Remove the brake hose (1) from the mounting bracket.
7. Remove the brake hose to caliper bolt from the brake caliper.
8. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper housing or the brake hose end.
Installation Procedure
Important: Install 2 new copper brake hose gaskets.
1. Assemble the 2 new copper brake hose gaskets and the brake hose bolt to the brake hose.
Note: Refer to Fastener Notice in Cautions and Notices.
2. Install the brake hose to caliper bolt and 2 new washers to the brake caliper.
-
Tighten the bolt to 40 N.m (30 lb ft).
Important: The brake hose must not be twisted. Make sure the brake hose is not in contact with any suspension component.
3. Install the brake hose (1) into the mounting bracket.
4. Install the brake hose retaining clip (3).
5. Remove the rubber cap or plug from the exposed brake pipe fitting end.
6. Connect the brake pipe fitting end (2) to the brake hose (1):
-
Use a backup wrench on the brake hose fitting end (1).
-
Do not bend the mounting bracket or the brake pipe.
-
Tighten the brake pipe fitting end (2) to 25 N.m (18 lb ft).
7. Bleed the hydraulic brake system. Refer to in Hydraulic Brake System Bleeding (Manual)Hydraulic Brake System Bleeding (Pressure) .
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Important: Ensure that the brake hose does not make contact with any part of the suspension or the tire/wheel assembly. If the brake hose
