Avalanche 2500 4WD V8-8.1L VIN G (2003)
Park Brake Cable Replacement - Right Rear (without RPO NYS)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer toLifting and Jacking the Vehicle in General Information.
3. Relieve the tension from the park brake cable by pulling down on the cable in front of the equalizer and removing the cable from the equalizer bar.
4. Disconnect the cable from the equalizer.
5. Remove the bolt from the rear axle clip.
6. Remove the cable from the differential clip.
7. Remove the cable from the mounting bracket by depressing the locking tabs.
