Avalanche 2500 4WD V8-8.1L VIN G (2003)
2. Position the NEW seal in the front cover so that the dimple (1) on the rear of the seal is in the 12 o'clock position.
Important: The engine front cover must be installed and the fasteners tightened while the sealant is still wet to the touch.
3. Apply sealant GM P/N 12346286 (Canadian P/N 10953472), or equivalent in two places (1) on the engine block where the front cover meets the
oil pan.
4. Install the engine front cover gasket into the front cover.
Important: The following method must be used when installing the engine front cover. Failure to follow the instructions will push the sealant out,
which may cause an oil leak.
5. Install the front cover and gasket.
5.1.
Hold the front cover (1) up to the crankshaft (2).
