Avalanche 2500 4WD V8-8.1L VIN G (2003)
Note: Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of the
bore. Prying will cause the sensor body to break off in the bore.
5. Remove the wheel speed sensor (5) from the hub/bearing assembly (4) shown on the 2500/3500 series.
6. Remove the WSS cable-mounting clip from the knuckle.
7. Remove the WSS cable-mounting clip from the upper control arm.
8. Remove the WSS cable-mounting clip from the frame attachment point.
9. Remove the WSS cable electrical connector.
Installation Procedure
1. Install the WSS (5) into the hub/bearing assembly (4) shown on the 2500/3500 series.