Avalanche 2500 4WD V8-8.1L VIN G (2003)
INSTALLATION PROCEDURE
1. Install the upper end of the intermediate shaft into the upper shaft.
2. Install the lower end of the intermediate shaft coupler.
2.1.
If you are reinstalling the same shaft, align the marks made during the removal procedure.
2.2.
Install the lower end of the intermediate shaft coupler onto the steering gear worm shaft.
3. Install the bolt to the lower shaft coupler.
4. Install the bolt to the upper end of the shaft.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
-
Tighten the upper bolt to 47 N.m (35 lb ft).
-
Tighten the coupler pinch bolt to 47 N.m (35 lb ft).
1. Remove the J 42640 from the steering column lower access hole.