Avalanche 2500 4WD V8-8.1L VIN G (2003)
5. Connect the upper ball joint to the steering knuckle and install the retaining nut.
Tighten
Tighten the upper control arm retaining nut to 50 N.m (37 lb ft).
6. Install the brake hose and the bracket retaining bolt to the steering knuckle
Tighten
Tighten the bolt to 9 N.m (80 lb in).
7. Install the outer tie rod to the steering knuckle.
8. Install the wheel hub and bearing assembly.
9. Connect the ESC link rod to the sensor, if equipped.
10. Install the tire and wheel.
11. Load the torsion bars. Refer to Torsion Bar Replacement.
12. Remove the safety stands.
13. Lower the vehicle.
14. Check the wheel alignment. Refer to Measuring Wheel Alignment (With Rear Wheel Steering) Measuring Wheel Alignment (Without Rear Wheel
Steering) in Wheel Alignment.