Avalanche 2500 4WD V8-8.1L VIN G (2003)
Stabilizer Link: Service and Repair
Rear Suspension
STABILIZER SHAFT LINK REPLACEMENT (15/25 SERIES)
REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to vehicle Lifting.
2. Remove the stabilizer shaft link nut and bolt from the frame bracket.
3. Remove the stabilizer shaft link nut from the ball stud.
4. Remove the stabilizer shaft link.
INSTALLATION PROCEDURE
1. Install the stabilizer shaft link.
2. Install the stabilizer shaft link nut to the ball stud.
IMPORTANT: When tightening the lower link nut verify that the inner jam nut bottoms out on the ball stud.