Avalanche 2500 4WD V8-8.1L VIN G (2003)
Shift Solenoid: Service and Repair
4L60-E/4L65-E
Control and Shift Solenoids Replacement
Removal Procedure
1. Remove the transmission filter.
Important: Do not remove the valve body for the following procedures. Removal of the 1-2 accumulator is necessary only if servicing the pressure
control solenoid.
2. Remove the 1-2 accumulator, if necessary.
3. Disconnect the internal wiring harness electrical connectors from the following components:
-
Transmission fluid pressure switch (1)
-
1-2 shift control solenoid (2)
-
2-3 shift control solenoid (3)
-
Pressure control solenoid (4)
-
torque converter clutch pulse width modulation (TCC PWM) solenoid (5)
-
3-2 control solenoid (6)
4. Remove the pressure control solenoid retainer.
5. Remove the pressure control solenoid.