Avalanche 2500 4WD V8-8.1L VIN G (2003)
4. Install the harness retaining pin (4) to the instrument panel.
5. Install the knee bolster deflector bracket and nuts (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nuts to 9 N.m (80 lb in).
6. Install the knee bolster.
7. Install the TORX(R) head screw.
Tighten
Tighten the screw to 1.5 N.m (13 lb in).
8. Roll the seal over the TORX(R) head screw.
9. Install the lower column trim cover.
10. Install the 2 TORX(R) head screws to the lower column trim cover.
Tighten
Tighten the screw to 3.5 N.m (31 lb in).