Avalanche 2500 4WD V8-8.1L VIN G (2003)
8. Install the transmission fluid pressure switch.
9. Install but do not tighten the valve body bolts which retain the transmission fluid pressure switch to the valve body.
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
Notice:
Torque valve body bolts in a spiral pattern starting from the center. If the bolts are torqued at random, valve bores may be distorted and inhibit
valve operation.
10. Tighten the valve body bolts in a spiral pattern starting from the center, as indicated by the arrows.
-
Tighten the bolts in the sequence shown to 11 Nm (97 inch lbs.).
11. Ensure that the manual detent spring is aligned properly with the detent lever.