Avalanche 2500 4WD V8-8.1L VIN G (2003)
6. To remove the axle shaft seal and the bearing together from the axle housing, use the J45857 (1) and the J2619-01 (2).
Installation Procedure
1. Install the axle shaft bearing using the J23690 (1) and the J8092 (2).
2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
3. Install the axle shaft seal using the J21128.
4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
5. Install the axle shaft.
6. Install the rear axle housing cover.
7. Install the tire and wheel assembly.
8. Fill the rear axle.
9. Lower the vehicle.
Rear Axle Shaft and/or Gasket Replacement
Rear Axle Shaft and/or Gasket Replacement
