Avalanche 2500 4WD V8-8.1L VIN G (2003)
4. Install the single clamp style boot onto the transfer case output shaft until the boot snaps into the groove on the output shaft.
5. Install the propeller shaft (5) to the front axle pinion yoke (1).
Align the reference marks made during removal.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the yoke retainers (7) and the bolts (6).
Tighten the yoke retainer bolts to 25 Nm (118 ft. lbs.).
7. If equipped with the double clamp style boot, use the J43218 to crimp the clamp until the dimensions shown are obtained.
8. Install the transfer case shield, if equipped.
9. Lower the vehicle.
