Avalanche 2500 4WD V8-8.1L VIN G (2003)
7. Insert a flat-tipped screwdriver or a small pry bar between the outer lip of the front output shaft seal and the transfer case.
8. Remove the remaining part of the front output shaft seal from the transfer case.
Installation Procedure
1. Install the J43484 (2) to the J8092 (11).
2. Install the seal onto the J43484.
3. Using the J43484 (2) and the J8092 (1), install the seal.
4. Install the front propeller shaft.
5. Check the fluid level. Add fluid if necessary.
6. Install the transfer case shield, if equipped.
Transfer Case Output Shaft Seal Replacement - Rear
Transfer Case Output Shaft Seal Replacement - Rear
Tools Required
^
J45756 Output Shaft Seal Installer
Removal Procedure
1. Remove the transfer case shield, if equipped.
2. Remove the rear propeller shaft.
