Avalanche 2500 4WD V8-8.1L VIN G (2003)
3. Remove the rear output shaft seal by prying it out with a flat-tipped screwdriver.
Installation Procedure
1. Using the J45756, install a NEW output shaft seal.
2. Install the rear propeller shaft.
3. Check the fluid level. Add fluid if necessary.
4. Install the transfer case shield, if equipped.
Transfer Case Input Shaft Seal Replacement
Transfer Case Input Shaft Seal Replacement
Tools Required
^
J36825 Output Shaft Seal Remover
^
J23907 Slide Hammer with Bearing Adapter
^
J42738 Front Output Shaft Seal Installer
Removal Procedure
1. Remove the transfer case.
