Avalanche 2500 4WD V8-8.1L VIN G (2003)
Heated Glass Element: Service and Repair
Stationary Window Reveal Molding Repair
STATIONARY WINDOW REVEAL MOLDING REPAIR
REMOVAL PROCEDURE
1. Lift up on the loose area of the reveal molding.
CAUTION: Refer to Glass and Sheet Metal Handling Caution in Service Precautions.
IMPORTANT: The window reveal molding fills the cavity between the body and window. If the reveal molding is stretched or damaged, it cannot
be reused and it must be replaced.
2. Clean the top edge of the window surface and the reveal molding with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened
lint-free cloth.
3. If the reveal molding cannot be reused, refer to Stationary Window Reveal Molding Repair.
INSTALLATION PROCEDURE
1. Verify all primers and urethane adhesive are within expiration dates.
CAUTION: Refer to Window Retention Caution in Service Precautions.
2. Use a new dauber in order to apply glass prep, clear #1, to the channel area approximately 13 mm (1/2 in) to the upper edge of the window.
IMPORTANT: Use care when applying the prep, clear #1, to the window. This primer dries almost instantly, and may stain the viewing area of the
window if not applied evenly.
3. Wipe the glass primed area immediately with a clean lint-free cloth.
4. Shake the glass primer, black #2, for at least 1 minute.
5. Use a new dauber in order to apply glass primer, black #2, to the top edge of the window.
