Avalanche 4WD V8-5.3L (2011)
3. Install the axle shaft bearing using the J 23690 (1) and the J 8092 (2).
4. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
5. Install the axle shaft seal using the J 21128 .
6. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
7. Install the axle shaft. Refer to Rear Axle Shaft Replacement See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Axle Shaft/Service and Repair.
8. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
9. Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Ring Replacement .
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
11. Fill the rear axle. Refer to Differential Oil Replacement .
12. Lower the vehicle.
