Avalanche 4WD V8-5.3L (2011)
Note: The rear axle wiring harness clip is a one way clip with a D-shape section. The clip can only be installed and/or removed in only one
direction.
6. Remove the right rear wheel speed sensor wiring harness clips from the frame and the control arm bracket.
Note: Do not attempt to pry the rear suspension sensor link rod from the rear position sensor ball stud.
7. Disconnect the right rear automatic level control sensor link rod from the sensor. Perform the following:
1. Support the sensor lever with your hand.
2. Twist the link rod ball in order to separate it from the ball stud.
8. Install a suitable adjustable jack under the rear axle.
9. Remove the right axle tie rod bolt (2) and nut (1).
10. Remove the rear axle vent hose from the rear axle, if necessary.
11. Remove the vent hose swivel clip from the rear brake crossover pipe, if necessary.
12. Remove the right rear stabilizer shaft link to frame bolt and nut.
13. Remove the right rear stabilizer shaft link from the frame.
14. Remove the right rear shock absorber lower bolt (4) and nut (3).
15. Lower the right side of the rear axle using the adjustable jack in order to remove the muffler.
