Avalanche 4WD V8-5.3L (2011)
19. Install the connector to the sensor.
20. From the technicians point of view, the FRONT of the sensor will have:
*
A pin hole (3) for the centering pin-Note location of the pin hole.
*
A flush rotor flange cuff (5)
*
An alignment mark (4) for installation
*
A foam ring (6)
21. From the technicians point of view, the BACK of the sensor will have:
*
Double D flats (1)
*
An alignment tab (2) for installing the sensor to the adapter and bearing assembly
Note: If you are reusing the existing sensor, align the marks on the flush rotor flange cuff before installation. The alignment mark must stay
aligned until the sensor is seated into the adapter and bearing assembly.
If you are installing a new sensor, the new sensor will come with a pin. Do not remove the pin until the sensor is seated. If the pin is not installed in
the sensor, order a new sensor.
22. Looking at the FRONT of the sensor, align the sensor with the steering shaft and install the sensor to the adapter and bearing assembly.
23. Install the connector to the sensor.
