Avalanche 4WD V8-5.3L (2011)
5. Install the power steering pump fitting seal (3) to the power steering pump assembly (1).
Caution: Refer to Fastener Caution See: Service Precautions/Vehicle Damage Warnings/Fastener Caution.
Note: Start the power steering fluid reservoir studs and the power steering pump flow control valve fitting by hand before finalizing any torques.
6. Install the power steering pump fitting (4) to the power steering pump assembly (1).
Tighten the fitting to 75 Nm (55 lb ft).
7. Install the power steering fluid reservoir studs (2) to the power steering pump assembly (1).
Tighten the studs to 58 Nm (44 lb ft).
8. Install the power steering pump assembly to the vehicle. Refer to Power Steering Pump Replacement See: Power Steering Pump/Service and
Repair/Power Steering Pump Replacement.
