Avalanche 4WD V8-5.3L (2011)
Note: Ensure that the axle shaft bearing is fully seated in the rear axle shaft housing.
2. Using the J 23690 - installer (1) and the J 8092 - driver (2), install the axle shaft bearing.
3. Using the J 21128 - installer , install the axle shaft seal.
4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
5. Install the rear axle shaft. Refer to Rear Axle Shaft Replacement See: Axle Shaft Assembly/Axle Shaft/Service and Repair.
6. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
8. Fill the rear axle. Refer to Differential Oil Replacement .
9. Remove the support and lower the vehicle.
